Description
C (%) | ≤ 0.008 |
Si(%) | 0.50 ~ 1.50 |
Mn(%) | 0.40 ~ 1.00 |
P(%) | ≤ 0.030 |
S (%) | ≤ 0.030 |
Cr (%) | 16.0 ~ 20.0 |
Ni (%) | 35.0 ~ 39.0 |
Mo(%) | 3.00 ~ 3.40 |
Other (%) | Co 16.0 ~ 22.0 Al ≤ 0.30 Ti 2.50 ~ 3.00 B 0.001 ~ 0.010 |
Condition of heat treatment | - |
Tensile Rm (MPa) | 1000 |
Yield Rp0.2 (MPa) | 550 |
Elongation A (%) | 15 |
Reduction in cross section on fracture Z (%) | 20 |
Impact AKV/AKU (J) | - |
Brinell Hardness (HBW) | 262 ~ 331 |
The alloy is usually produced by BEF & AOD followed by electroslag remelting (ESR) / VAR if necessary for special purpose. Bars and, where applicable, forgings are subjected to ultrasonic examination based on the different levels according to the buyers' requirements. 100% Ultrasonic test ASTM E2375 /SAE AMS 2154 /SEP 1923 /GB/T 4162 /EN 10228-3. Bars are usually supplied black/bright in the annealed condition. |
Forms and Shapes: Round bar (Diameter): 5.50 ~ 650mm Square bar / Flat bar: 3 ~ 650mm Wire rod (Diameter): 0.10 ~ 16mm Steel strip via cold rolled: T0.1 - 3mm X W5 - 650mm X L (or in coil form) Forging piece: Different shapes based on OEM |