Description
C (%) | ≤ 0.05 |
Si(%) | ≤ 0.30 |
Mn(%) | ≤ 0.50 |
P(%) | ≤ 0.030 |
S (%) | ≤ 0.030 |
Cr (%) | 14.0 ~ 15.0 |
Ni (%) | 6.00 ~ 7.00 |
Mo(%) | ≤ 0.30 |
Other (%) | Al ≤ 0.10 Ti 0.55 ~ 0.90 |
Condition of heat treatment | - |
Tensile Rm (MPa) | 1350 |
Yield Rp0.2 (MPa) | 860 |
Elongation A (%) | 4 |
Reduction in cross section on fracture Z (%) | 28 |
Impact AKV/AKU (J) | - |
Brinell Hardness (HBW) | - |
The alloy is usually produced by BEF & AOD followed by electroslag remelting (ESR) / VAR if necessary for special purpose. Bars and, where applicable, forgings are subjected to ultrasonic examination based on the different levels according to the buyers' requirements. 100% Ultrasonic test ASTM E2375 /SAE AMS 2154 /SEP 1923 /GB/T 4162 /EN 10228-3. Bars are usually supplied black/bright in the annealed condition. |
Forms and Shapes: Round bar (Diameter): 5.50 ~ 650mm Square bar / Flat bar: 3 ~ 650mm Wire rod (Diameter): 0.10 ~ 16mm Steel strip via cold rolled: T0.1 - 3mm X W5 - 650mm X L (or in coil form) Forging piece: Different shapes based on OEM |