AISI 321 Aunstenitic Stainless Steel Flat Bar
This page provides AISI 321 Round bar, Flat bar, Plate, Sheet in stock, AISI 321 datasheet, mechanical properties, chemical element, performance specifications.
Product parameters | |
Material Category:: | Austenitic Stainless Steel |
Place of Origin: | P.R. China |
Heat Treatment Practice:: | Solution annealed 1050 ℃, water or air cooled |
Production Lead Time:: | Within 25 days after 30% deposit prepayable |
ISO 9001-2015 Certified by:: | UKAS |
Unified Social Credit Code:: | 91510871777942750J |
Company ISO Register No:: | UQ211218R0 |
Description
Material Short Introduction:
ASTM A182 is Material Standard Specification for Forged Stainless Steel Pipe Flanges and Stainless Steel Forged Fittings. AISI 321 is usually produced by BEF & AOD followed by electroslag remelting (ESR) / VAR if necessary for special purpose.
Bars and, where applicable, forgings are subjected to ultrasonic examination based on the different levels according to the buyers' requirements.
100% Ultrasonic test ASTM E2375 /SAE AMS 2154 /SEP 1923 /GB/T 4162 /EN 10228-3.
Bars are usually supplied black/bright in the solution annealed condition.
Applications:
Commonly used in industries such as offshore, marine, food, paper mills, oil field and aerospace.AISI 321 is used for components such as fasteners, couplings, screws, bushings, studs, fittings, valve stems, roller, wear rings.
Commonly used in industries such as offshore, marine, food, paper mills, oil field and aerospace.AISI 321 is used for components such as fasteners, couplings, screws, bushings, studs, fittings, valve stems, roller, wear rings.
All Grades Comparison
AISI | ASTM | UNS |
---|---|---|
AISI 321 | ASTM 321 | UNS S32100 |
Chemical Composition (mass weight %)
C | Si | Mn | P | S | Cr | Ni | Mo | Other |
---|---|---|---|---|---|---|---|---|
≤ 0.08 | ≤ 1.00 | ≤ 2.00 | ≤ 0.045 | ≤ 0.030 | 17.0 ~19.0 | 9.00 ~ 12.0 | 3.00 ~ 4.00 | Ti 5 X (C + N ) ~ 0.70 N ≤ 0.10 |
Mechanical Properties Under Room Temperature.
Condition of heat treatment | Tensile Rm(MPa) |
Yield Rp0.2(MPa) |
Elongation A(%) |
Reduction in cross section on fracture Z (%) |
Impact AKV/AKU(J) |
Brinell Hardness(HBW) |
---|---|---|---|---|---|---|
Annealing | ≥ 515 | ≥ 205 | ≥ 40.0 | - | - | ≤ 217 |
Shapes & Dimensions
Round bar (Diameter): 5.5 mm to 500 mm
Wire rod (Diameter): 1.0 ~ 13mm
Steel strip via cold rolled: T0.1 - 3mm X W5 - 650mm X L (or in coil form)
Heavy/middle plate via hot rolled: T50 - 200mm X W80- 1200mm X L1000-3000mm
Forging piece: stepped shafts /other different shapes based on OEM.