Description
C (%) | ≤ 0.15 |
Si(%) | ≤ 0.75 |
Mn(%) | ≤ 0.75 |
P(%) | ≤ 0.015 |
S (%) | ≤ 0.015 |
Cr (%) | 15.0 ~ 20.0 |
Ni (%) | 43.0 ~ 64.0 |
Mo(%) | 3.00 ~ 5.00 |
Other (%) | Co 13.0 ~ 20.0 Al 2.50 ~ 3.30 Ti 2.50 ~ 3.30 B 0.003 ~ 0.01 Cu ≤ 0.15 Fe ≤ 4.00 |
Condition of heat treatment | - |
Tensile Rm (MPa) | 1200 |
Yield Rp0.2 (MPa) | 800 |
Elongation A (%) | 12 |
Reduction in cross section on fracture Z (%) | - |
Impact AKV/AKU (J) | - |
Brinell Hardness (HBW) | 310 |
The alloy is usually produced by BEF & AOD followed by electroslag remelting (ESR) / VAR if necessary for special purpose. Bars and, where applicable, forgings are subjected to ultrasonic examination based on the different levels according to the buyers' requirements. 100% Ultrasonic test ASTM E2375 /SAE AMS 2154 /SEP 1923 /GB/T 4162 /EN 10228-3. Bars are usually supplied black/bright in the annealed condition. |
Forms and Shapes: Round bar (Diameter): 5.50 ~ 650mm Square bar / Flat bar: 3 ~ 650mm Wire rod (Diameter): 0.10 ~ 16mm Steel strip via cold rolled: T0.1 - 3mm X W5 - 650mm X L (or in coil form) Forging piece: Different shapes based on OEM |